Using linear referencing in ArcGIS to plot line data

[المشرف العام]

I have just started using the linear referencing tools in ArcGIS 10.2 but I'm having a bit of trouble. I'm trying to plot schemes as line data on to our road network layer which is also line data using start and end points (almost like routes).

This is what I have so far :

1. I've successfully created a route layer from our road network line data. This layer is split into around a 1000 sections ranging from 50m to 2500m with each having there own SECTION_ID.
   
2. I have a table which has numerous schemes in each with the following attributes : SCHEME_NAME, START_SECTION_ID, START_CHAINAGE (How far into that section in meters), END_SECTION_ID, END_CHAINAGE_ID (How far into that section in meters).
   

I'm using the Make Route Event Layer tool to create the schemes on the road network layer using the SECTION_ID as the route identifier field. The problem is I can only seem to plot the schemes which start and end in the same SECTION_ID as there is no option to provide an additional end route identifier field.

I'm not sure I'm going about this the right way so if anyone could give any advice or put me out of my misery I'd be most welcome .

Many thanks.



أكثر...