From an issue with buffer overlaps, there was this weird problem occurring with an intersect not matching up with the buffers in Arc GIS Pro as shown below:
Upon opening the same exact buffer, with same layer coordinate system, same buffer width, buffer source points, etc. I found that the two softwares were viewing them different as shown below:
In the image above, the buffers were loaded into ArcMap 10.3 (left) and ArcGIS Pro (right). Why is this happening? All of the properties of the layers are exactly identical, but there are clearly some discrepancies. How can I fix this?
أكثر...
Upon opening the same exact buffer, with same layer coordinate system, same buffer width, buffer source points, etc. I found that the two softwares were viewing them different as shown below:
In the image above, the buffers were loaded into ArcMap 10.3 (left) and ArcGIS Pro (right). Why is this happening? All of the properties of the layers are exactly identical, but there are clearly some discrepancies. How can I fix this?
أكثر...